Making of Tear Away. 👨‍🔧 Calibration hose glued to the liner. Boldan Pipe Technologies. Liima-avopää

Here is an instructional video of the calibration tube glued to the liner.
This technique is commonly used with open-end installations.
www.boldan.fi
Liima-avopään valmistus.
#boldan #trenchless #cipp
Kanalsanierung, remont kanalizacji, rénovation des égouts, avlopp renovering, renovación de alcantarillado, aggiornamento fogna, renovação de esgoto, канализация ремонт, kloakk fornyelse, 下水道の改修, rekonstrukce kanalizace, renovering kloak, rioolrenovatie, חידוש ביוב, تحديث المجاري, riool opknapping, grabenlose Technologie, Métodos não Destrutivos (MND), bezvýkopové technologie, Sans Tranchée Technologies, Tecnologie No Dig, Tecnología Sin Zanja, Sleufloze technieken, Tehnologii fără Săpătură, Kazısız Teknolojiler, Trenchless technology, CIPP, Cured-in-place pipe, Бестраншейные Технологии, Rehabilitación de tuberias sin apertura de zanja, Reparación de Tuberías con Manga de Inversión

[@laurikeranen]

Asiallisia videoita :) nämä videot on varmasti kullan arvosia varsinkin uusille tekijöille tällä alalla. Hyvää työtä (Y)

[@andrehbellini]

Is there any data sheet or manual how to do that would you provide me?

[@boldan-pipetechnologies4866]

Hi, could I have your email address so we can send you the instructions?

[@andrehbellini]

Hey mate, for how long you allow the glue to dry after applied? Would that influence in the strength of it? Cheers

[@AntoineHAMON]

How the calibration hose removed? When the liner polymerized.

[@boldan-pipetechnologies4866]

The lining rope will be attached to the Calibration Hose, and the Calibration Hose will be removed by pulling the rope after the liner has cured.

[@AntoineHAMON]

@@boldan-pipetechnologies4866 Ok thanks

[@ryanpaiement5693]

Is this Tear away used so you don't need to invert a the cal tube into the liner for curing? Also known as a liner end cap?

[@boldan-pipetechnologies4866]

Yes, it's the same thing - we just call it "Tear away". 👍

[@ryanpaiement5693]

That’s a great video! Thanks for making it.

[@davidbarbosa8331]

what is the brand of your glue does it support the heat of the steam engine?

[@boldan-pipetechnologies4866]

Hi David, the glue is Boldan Open End Glue 0,3 L, and it is suitable for steam curing. 👍

[@mikematij2]

There's no fucking way I'm trusting that

[@boldan-pipetechnologies4866]

More than a hundred thousand homes have been fully relined (all the sewers) with the Boldan In-House Lining System. So, these tear-away liners must have been installed hundreds of thousands!