Making Wooden Planter Stands

Check out how to make these planter stands! The design is clean and simple, and they work great with concrete planters. Each planter consists of two pieces that fit together with a half lap joint and as a bonus, they can pack flat.
For the joinery between the legs and cross pieces, I creating loose tenons using the beadlock basic kit. This was my first time using this jig, and in the video, I share my experience with it.
DIY Concrete Planters:
• How to Make DIY Concre...
How to make an accurate crosscut sled:
• Why You Need a Crosscu...
Head to my website to find the cut list for all three sizes of the planters:
www.mosermakes.com/articles/w...
#diy #woodworking #planterstands #flatpack

[@MichaelJosephJr934]

Hats off to you for showing the difficulties. Thank you!

[@mikehawkins5418]

I like the honesty of your process and how you share your problem solving.

[@henryarroyo9305]

nice and clean job LOVE IT!

[@TheMoonlightCraftsman]

Love the modern design mr. moser

[@alkanath]

beautiful!

[@ranger2316]

Thank you.

[@kuochen5709]

Awesome

[@dmitrikmatveyev6525]

КРАСИВО и СУПЕР ☘️🍀🌿

[@milkod2001]

Super simple yet quite elegant.i.ll do very same just maybe round them a bit.

[@anthonvanderneut]

I would use a a depth stop for the drill. It is not so important if you go to far in the horizontal parts, but if you drill through the vertical ones, you'd see it on the outside. If the drill did come with the set, they should have included such a stop.

[@kekipark77]

nice

[@softmetals3702]

add a little saw dust to under the sled, youll have a smoother glide when cutting

[@roberttangen2942]

Wonder if that jig can used with a drill press to reduce the amount of rotational wobble or is that even possible

[@dickvankoughnett2331]

What about just going up one fraction in size on the drill bit ?

[@rangerider51]

I’d rather know how to make cabinets for my van while living in it and only having a Ryobi drill and jigsaw and tools. I don’t have a plus nut tool but should get one and learn how to install them. Have a 🙂 day.

[@MelannJur]

Where do you get your wood?

[@martinr4637]

What's the cost of making these vs buying some?

[@benw4361]

You didn't measure the pieces after cutting or using the tool? I'm surprised you couldn't eyeball the misalignment.

[@carmenzamendieta8145]

Si aguantará peso ?

[@brandyhawking7908]

I did the same with Woodglut :)

[@aztecwarrior9729]

too much work for a simple base. I don't have any of those tools

[@gelsvlog]

exactly

[@milkod2001]

You could do it all with hand saw and a cheapo drill if ur stuck for cash.

[@constantinosbou]

Just change the project to fit your wallet and your tools man! Instead of holes and glue, just take a small wood piece and screw everything together or something!

[@sharonvaughn8062]

If you are offering a “how to” video it might make sense to start over in order to show an appropriate working technique. I felt that I’d wasted time watching how you repaired a problem I could avoid, had you shown a technique that worked.