Makita 9557NB Angle Grinder Armature Replacement | Burnt Motor Repair

Is your Makita angle grinder making a strange noise? Significantly reduced power? Your Armature may have failed. This video will walk you through the steps of replacing an Armature. Part Listed Below.
Armature:
amzn.to/3rJLDqe
Contact Me:
[e-mail]
(Disclaimer) As an Amazon Associate, I earn a small commission from anything purchased in the amazon link(s) posted in this description. I use these funds to purchase new gear and reinvest into the channel. Thank you!

[@joecahill4164]

Great teardown and rebuild demo...good teacher..step by step , explanation, and tempo all good

[@tropicolcol]

Great vid thanks, when I turn power back on I use the plug switch so I am not holding the unit, just in case

[@mortezaamani260]

Clearly explained. Thank you very much 👌

[@GS1181]

Remove seal and install it on while removed then put the whole thing back in. That’s how I do it and it’s much easier.

[@andjuju6476]

Good video, could improve by cleaning the grinder.

[@TheNoparking]

You should have replaced those brushes.

[@OldSoulMillennial]

why?

[@tomahoks]

No need if they arent worn out.

[@gregrojna3336]

new arm ... old brushes :(

[@OldSoulMillennial]

No need to replace them if they are in good condition