Massive clog in my Bambu Carbon X1C

[@madeautonomous]

Just got mine a week ago and loved the simplicity, but this is shocking! I hope Bambu can investigate this and make improvements soon.

[@kevinlieb]

@@madeautonomous don't trust it too much. I had fantastic success for 100 prints before this

[@williamwilson4049]

arn't they supposed to detect fails? if so this is a huge fail on Bambu.

[@kevinlieb]

@@williamwilson4049 it has spaghetti detection but this one's went straight to meatballs and it never did detect. It didn't even stop when the cover got knocked off very disappointing I had put too much trust in this printer which had been flawless up till now

[@stuem163]

Buy a new one.....