Mastercam Lathe Threading

Mastercam lathe threading with info on pluge parameters, thread relief, model prep to major diameter.

[@agg42]

20:04 when you're in a selection screen you can use the keyboard shortcut 'Q' to quickly change autocursor to quadrant

[@m.j.khnowledge]

Thank for the video help

[@cheizaguirre5494]

Thank for the video help. I have a issue when i click the chain for the radius it doesn’t generate like urs it says no remaining material found ?

[@raider1628]

On the grooving cycle, is there any way to make the finish pass run one pass rather the one side lift up and do the other side? hope that makes sense.

[@BrianWickhamMFG]

Not that I know of. Groove toolpaths want to cut into the part as that is the pressure the tools are designed for.