MatrixGold Halo Ring

[@jayneweber5510]

🍿🍿🍿Popcorn‼️ 😄 👍🏻Classic design. This video has soooo many valuable strategies for a clean, castable piece! 🔥 Great video‼️ Thanks Don!

[@donsjewelrymakingandjapantrave]

It is isn't it. Very simple but you can sell all day long with different stone configurations. Thanks so much for the comment and all your support. Much Appreciated.

[@aretthegiant537]

I learn more from you than I would ever learn with Gemvision you are the GOAT

[@donsjewelrymakingandjapantrave]

lol Thanks so much. It means a lot. Hope the content is helping. I really am thankful for all your support and time.

[@joaoluizxavier6157]

You bless me a lot with your tutorials, thank you!

[@donsjewelrymakingandjapantrave]

You're very welcome! Hope they are helping. Thanks for the comment and the support.

[@chzaryab488]

Nice video sir Thank you.🙏🙏🙏

[@donsjewelrymakingandjapantrave]

More than welcome as always. Thank your for taking the time to comment and give me motivation. Really!

[@cansahinoglu]

Thanks a lot Don.

[@donsjewelrymakingandjapantrave]

Still the best. lol Really can't thank you enough.

[@humbertocastillo9439]

Thanks Don's excellent tutorial.

[@donsjewelrymakingandjapantrave]

Very welcome! Hope it is helping. Really appreciate all your comments and support.

[@balentinecojewelers1595]

My boolean difference keeps failing at 20:17, but grant it I was not able to do the taper because it would just go back to the initial extrusion even though it would show in the dynamic commands that a taper had been run. I have the McNeel Wiki Boolean FAQ, but I don't really understand. Have you done any videos on how to determine why a boolean has failed?

[@donsjewelrymakingandjapantrave]

There are a few reasons Booleans don't work. But the main ones are if they are not closed watertight surfaces or the share a common plane. First of course make sure they are watertight closed surfaces. Next make sure that they are not sharing a common plane. If they are just click on one and move it by clicking on the gumball on one of the arrows and moving it .001 in the up or down direction. There is also another reason and that is maybe you have duplicates that you are selecting by selecting them all. Try ungrouping and doing them one at a time until you find the one that is not working. The last reason is sometimes Booleans don't like groups. lol they prefer to just have the surfaces you are trying to cut or join together. So ungrouping again is an option. But good ideal on the video of why they don't Boolean video.