Like the gimbal repair video and the one on the rear leg repair. A couple of comments 1. Don't bother with the razor blade just use a plastic tool to pry the camera shroud off. 2. to remove the roll arm cap and the Yaw arm top cap; Just poke a small screwdriver shaft through the centre hole where the cable is, and push. The cap will pop off. 3. First connect the 'roll arm' to the 'yaw arm'; locate the appropriate ribbon cables and tighten the roll motor screws(one screw is near to the loom centre connector). Before threading the loom carefully thread the yaw motor ribbon up through the gimbal support bracket and fix the three yaw motor screws. Check that the screws are not too long. Some replacement parts have thinner top plates and the original screws can foul the motor. The yaw arm should rotate freely except when the side stops collide with the centre stop of the support bracket. 4. When threading the cable loom start by threading the 'top end' ( the loom end, furthest away from the centre connection) into the centre hole of the roll motor; back up through the yaw arm and up through the yaw arm motor. 5. now pop the yaw arm cover back on connect the centre loom connector 6 . fix the pitch motor in place before connecting the pitch motor ribbon
@vishalmohammed3 жыл бұрын
Very good and informative video, a small suggestion from me is to please magnetize your tools which will make the work easier and faster.
@vancuy2 жыл бұрын
Hi Mate, My Air 2S camera tilts upwards after calibration. this happened after a crash. any advice on how to fix it?