Mavic pro battery disassemble and calibrate

Mavic pro battery disassemble and calibrate
Mavic air battery repair (activation): • Battery Mavic Air Repa...
Mavic battery repair (activation): • Battery Mavic Pro Repa...
Phantom 4 battery repair : • Phantom 4 battery repa...
Phantom 4 battery repair (activation): • Phantom 4 battery repa...
Phantom 4 battery repair (full video): • Battery Phantom 4 Repa...
Mavic 2 battery disassembly : • Mavic 2 battery disass...

[@KSDAirPhoto]

Hi Mihai, my battery became famous. By the way i use it and it performs very well. Thank you my friend

[@parnoboy1650]

how to solution bloated battery or replace cell? Thank's

[@aleksusnemo4284]

mavic pro changer not calibre battery ???!

[@mihaigsm2003]

never

[@wanderlustsick1538]

Hi sir. Where can i download the program ur using? And is it free?

[@MrBerenguer67]

Bom video pode me tentar explicar o quê que fez obrigado

[@rotalr]

Uma bateria de Mavic tem 3 células (3 baterias menores em conjunto). O problema é que quando uma dessas baterias individuais fica mais fraca que as outras gera um desequilíbrio e o drone não liga ou liga mas nao deixa acionar os motores. O que ele fez foi colocar um pouco de carga nessa bateria que esteva mais fraca para que ele ficasse equilibrada novamente.

[@ronvanbree637]

@@rotalr This is also what i did, but when doing this, the other 2 cells went up in voltage too. How is this possibel, and how can I prevent this? Thanks!

[@on220]

Ни че не понял, но очень интересно )

[@aleksusnemo4284]

учи язык деппил

[@YHONYcheloALVE]

tan mala calidad tienen los mavic pro

[@ua9851]

Cells balancing could be done easier, and even without disassembly. 1. Fully charge the battery 2. Load service balancing firmware. 3. Wait some days until chip equalize the cells by current bypass over most charged one 4. Load stock firmware back 5. Make relearning cycle Profit

[@TecDrone]

where do I find this firmware file ??

[@zzinhoo]

where do I find this firmware file ??

[@mihaigsm2003]

1.I never see any service balancing firmware 2. If battery was dead how to load firmware? 3. Lost many time, can't check cells if dead, if try to charge broken cells with no bms can get fire

[@ua9851]

@@mihaigsm2003 if battery is out of balance it does not mean it's dead. Out of balance is quite common after long storage. So battery state is about 10 to 30% when was not used in the off-season, and being fully charged and inserted in the drone Dji Go app shows 'Cell broken', 'Unable to take off'. In such scenarios PFF not set. All you need is to balance the cells. But the method you showed with case cracking is not the best one, the plastic sides is well glued and difficult opened, then it looks not presentable.

[@mihaigsm2003]

@@ua9851 u have service balancing firmware?