Thank you for your content on your SN95. I wish you still had it and we're producing more chassis upgrade content. Your videos had the best install detail.
@chrisvela54622 жыл бұрын
About to get mine welded into my 01 coupe in a few days. Already did the MM Strut Tower Brace and I'm loving it so far
@fishsquishguy18333 жыл бұрын
Plan on any update vids with your Cobra? Great job on your vids! Appreciate all the tips and even showing any f*ck ups you had too. Very honest and helpful, thanks dude!
@truckandroll9893 жыл бұрын
Actually yes. Check out my latest video. Just dropped yesterday ;)
@blueishwhite2 жыл бұрын
one of the best mods you can do i have steeda sfc on my cobra and next i think was my mm panhard bar
@NewEdgeDesigns2 жыл бұрын
Will you be able to change the transmission mount without problems in the future??
@truckandroll9892 жыл бұрын
I believe so yes. I think you can unbolt it further in.
@NewEdgeDesigns2 жыл бұрын
@@truckandroll989 thanks for the quick reply…
@jamesa62723 жыл бұрын
I have a 97 Gt convertible I plan on putting sub frame connectors in. I’m going to do them myself also. I’m not a pro welder either. I’m using a harbor freight flux core welder. Fingers crossed nothing goes wrong and my doors will close after the job. I like the exhaust. What mufflers are you running? Slp?
@truckandroll9893 жыл бұрын
Just take your time with the subframes and make sure you get a tight fit before welding. Mine required some bending to fit which is OK. I am running FRPP shorty headers, BBK catted X pipe, SLP LM1 mufflers, and SR over axle pipes
@jamesa62723 жыл бұрын
@@truckandroll989 awesome. Thanks for the info. Nice exhaust setup. I just put a 03 Pypes H Pipe on the 97 vert. Catless with flow original 40s with 5.0 resto tailpipes and 3.5inch tips.
@jamesa62723 жыл бұрын
@@truckandroll989 Just got done installing stifflers full length sub frame connectors. Your video helped me out. I had the front tires on ramps and the rear tires on cinder blocks. Worked out good. Took about 4 hours. Had to cut the trans mount bracket so the sub frame connectors would fit flush. Man do you really have to have a flat frame for these or else your just filling in holes with the weld. I cut a heavy aluminum baking pan to block the fuel lines when I welded the outside passenger side. Like you said it’s definitely not a night and day difference but you feel a little more solid going over bumps. That’s pretty much it....