I'm doing the lamp restore too. According to the PCB schematic , the lamps on the PCB are 12/14 volts 80mA ( service manual) . The other crappy thing I ran into is the flexcable from the lamp PCB to the secondary PS. It disintegrated
@ScottFrye000111222 Жыл бұрын
For those who desire oldschool lamps , the PCB mount lamps are JKL7382
@abyssalsoul62166 ай бұрын
Thank you very much for this video!
@LoganNolag3 жыл бұрын
I'm pretty sure the thick double sided tape they use to attach the plexiglass and switch bezel is some kind of tape similar to 3M VHB which is available in many different thicknesses. It's the same kind of tape they use to attach badges to cars.
@AudioElectronicsChicago5 жыл бұрын
Well done
@adriancjones4 жыл бұрын
Great video. I. Getting ready to replace some of the lamps in my 7205 amp. I was thinking of going to leds. Is there a problem doing that, an incompatibility or something? Also I’ve been getting an intermittent fault light showing up on one of the amps. Is there something obvious I should be looking for when I open it up?
@HubertKonrad Жыл бұрын
Where can I buy these bulbs?
@ezaccarezi4 жыл бұрын
Hi. I need a new Face Plate Glass for my Mcintosh MA6200. Where Can I buy one?
@recycledsound4 жыл бұрын
Elber Zaccarezi directly from Macintosh!! Give them a call!
@stefansetadi4 жыл бұрын
@@recycledsound I email them few days ago. They redirect me to local (Indonesia) dealer. :(