in this video tell about how to fit up of neck weld flange with tee with very easy way this video help fitter and fabricator to fit up of material like elbow and flange each other #pipe #flange
Пікірлер: 16
@chandesharkumar6677 Жыл бұрын
Very nice good information sir jee🙏
@mundrikachauhan53843 ай бұрын
Bahut achcha video sar🎉🎉❤
@Titter_offical9 ай бұрын
Mash Allah good job ustad❤
@imtiyazansari2905 Жыл бұрын
Good job
@rizwanmalikcssАй бұрын
Slipon ko kesy fit karty hn wo dikhao
@hallagullawithhelp1043 Жыл бұрын
Good
@hallagullawithhelp1043 Жыл бұрын
Nice
@user-jv7cz5xp5k Жыл бұрын
yaar scare kya hota hai pakistan ki bhi alag hi english pronounciation hota hai
@sanjaysharmagazipuri9251 Жыл бұрын
Slip flange PCD. Pipe. Ka. OD. Par. Hota. Hai
@josepineda3072Ай бұрын
😂😂😂😂
@bobprice924410 ай бұрын
Why does everyone on KZbin take the longest way to do anything about piping? Eccentric's, t's, long or short ell's. Toss out that book you read on how to do it and use your head. I would have welded that before the video ended
@mechanicalfabrication78610 ай бұрын
Hahaha v good
@bobprice924410 ай бұрын
@mechanicalfabrication786 I don't know about you, but a 6x4 eccentric reducer measures 6-5/8 +4-1/2. 6-5/8 minus 4-1/2 = 2-1/8. 2-1/8÷2=1-1/16. I have a piece of 8" angle that when clamped to my table is square to my table. Get a block or stack of metal 1-1/16, push the 6" side up against the angle and roll it, keeping it flat against the angle until the 4" end rests on the 1-1/16 stack. Measure from the table up the side and mark it at 3-5/16. There's your centerline.