Thanks for this mate! Sorted my car out like this today
@ad166bt Жыл бұрын
The issue with the tailight seals lies with the installation which was done incorrectly from factory. The adhesive part of the seal should be placed on the chassis of the car and not on the tailight. I replaced both seals on my car as a preventative maintenance and installed genuine MB seals which werent that expensive. Also installed two covers which I found in MB EPC software and it has been dry for three years now. About placing the rear SAM in a plastic bag I would be worried a bit since it may generate heat and be unable to dissipate that heat which may lead to other issues.
@Dinamikass Жыл бұрын
so i have installed wrong ? Adhesive must be in chassis side ?
@seemaab8 ай бұрын
@@Dinamikassyes! You did it wrong
@brendyxis6 ай бұрын
Ahoj, to tesnenie si kupil kde ? Mozes dat odkaz alebo aspon tip ! Dakujem !
Your installation is incorrect. The seal is glued to the body and not the tail light. It will eventually leak again. Take it apart and fix it correctly.
@Dinamikass5 ай бұрын
are you sure ? I have opened couple mercedes from factory and it was like that like i did ....
@wallycoach28435 ай бұрын
Yes I am sure, the employees at the assembly plant messed it up by glueing it to the tail light. It eventually was resolved as the years went on.
@Dinamikass5 ай бұрын
so nice i made wrong movie :DDDDD
@TommMan4 ай бұрын
Leak sam modul solution 2 kzbin.info/www/bejne/pWGUoqeOpdCEhbMsi=wYQDko2bp3BiTrCz