METAL ROOF SCREWS Leaking - 90% of metal roof leaks can be stopped with 1 tool and 1 man

[@boeingfan7179]

I love your videos. You’re old school thorough and do a great job.

[@FlatRoofDoctor]

I appreciate that!

[@abadpoet6005]

good work line by line.

[@mikeadriano7747]

Great video i have a question. Can you put silicon patch on your entire roof ?

[@asunciongaristaramirez8293]

Vientos sr Nash eres el mejor saludos

[@FlatRoofDoctor]

Vientos

[@philipskrusso1153]

Very helpful Thankyou

[@FlatRoofDoctor]

Thanks

[@stuartmclaren2402]

I am very surprised that screws are rusting only after a short time and the roof needing maintenance. We live in a much wetter climate, where some say it rains uphill so with a roof like that problems would occur sooner. After 40 years, I find some nails securing the roof rusty. I think it is a bad design that the roofing sheets have to be screwed down in the water channels rather than on the ridges. So water will pool around the screws. One idea you can try is dip the screw tips in mineral oil before screwing them in to provide extra protection against rust. Even used car engine oil will be good, and it costs nothing. I think the screw heads and neoprene washers should be sealed when first installed. Will walking all over the roof cause damage as some iron roofs will dent and distort, leading to leaks and water pooling if not taking care?

[@Handlethetruth666]

Now you can’t get the bolts off

[@johnkimble2361]

Why is the product so expensive. Lot people could use this will all storm damage. But prices are very unafforadable to the common person. Less you are a roofing contractor.

[@paulsuli3581]

You fix the screws that backed out or replaced the screws both bigger ones. then you put the sealant on the screw. Now the question is will the screw back out again after all that is done

[@FlatRoofDoctor]

nope. They backed out because they lost the torque due to the washer drying out. After Re-torque the washer will not dry out further and therefore the screws will not loosen up. This is a must do for any metal roof installation after 3 - 5 years.