Not a fan of these methods. You should use drip edge that you can wrap around the panels from both the bottom and the sides - this is both cleaner and stronger, plus there are no visible fasteners in the panel, hence no future leak concerns. The panel also does not stick up at the base with a cleat as shown toward the end of the video.
@chrismagnum27103 жыл бұрын
What this guy said !!!!
@douglasthompson27407 жыл бұрын
On the hidden fastener install what provisions are made to keep the 'snow curl' from tearing off the gutters? Part of the advantage of having 2" overhang is it gets the snow curl out away from the gutter somewhat. Thanks. Doug
@alextaylorson78126 ай бұрын
By using exposed screws is it truly a standing seam installation?
@brianrobbins34994 жыл бұрын
I never cut the panel at the eave when I can cut the top
@1weirddoe5716 жыл бұрын
Seam fail rate--how many seams out of say 100 or 1000 has wind popped up?
@spawntarget15878 жыл бұрын
Everyone has slightly different ways of cutting the panel, if your cutting 10 inches or so off of a panel you should be cutting in the other direction so you are prying up the 10 inch side while cutting so that the panel your installing remains flat.
@edulmer66793 жыл бұрын
you're not your in this case
@stewmeat92615 жыл бұрын
By using the exposed method . Hanging the sheet over 1 1/2 " wouldn't that expose the unpainted surface when looking up?
@JohnSparkmanandBlackTopHerd5 жыл бұрын
more like the crappy method, and not what I was looking for... waste of time
@SpetznazSamson4 жыл бұрын
The gutter usually covers it so you will not see it.
@jaype7418 жыл бұрын
can this be installed over an existing shingle roof or battens or perhaps cross battens?
@josephtoombs69333 жыл бұрын
Dont do that. Have pride with your work
@mariamilton-talbot46648 жыл бұрын
install on plywood or wood/metal purlin?
@Abcmetalroofing8 жыл бұрын
Hi Maria! Thanks for your question. Installation of S-16 must be done over a solid sheeted substate. We recommend 5/8" OSB or plywood. We also conduct our uplift and impact testing with this type of sheeting.
@mariamilton-talbot46648 жыл бұрын
They're pancake heads not pan heads :)
@josegarcia7812 Жыл бұрын
I didn’t like any of thos ideas. How he install. Nop. There’s other way to do it better