Contact Bernie from Mettex on 01782 712345 for information on how get your POP Airtools repairs or serviced mettexairtools.co.uk/air-tool-service-and-repair/
@billycarter6682 Жыл бұрын
Does the Proset Xt2 or XT3 have a duty cycle to prevent inner seals from heating up and going bad. Or can they be used constantly in an 8hour shift? Manual isn’t clear
@bradschmidt77052 жыл бұрын
My proset XT 3 does not release/return after the trigger is released. What would cause this?
@soybean44894 жыл бұрын
So I’ve got the priming kit and everything does it have oil in it or is it just air????
@carminepaola16324 жыл бұрын
What type of oil do you put into a FAR tool rivet
@leehatfield44654 жыл бұрын
Hi, we have 5 of the XT2 tools. If you hold the trigger on one of them it pulls but then keeps sending air out of the front holes of the chamber until you let go of the trigger. The others do not do this. It seems to still work but it doesn't seem to work as well. Could it be a seal that has gone? Thanks in advance of any answers.
@bernieshaw17904 жыл бұрын
Hi Lee. We have seen that fault before. It is a seal that has gone on the bottom piston. We can happily get the tool looked at for you or we can offer a drawing and spares if you are confident in repairing yourselves. Please contact me on airtools@mettex.co.uk and I can assist you further.
@leehatfield44654 жыл бұрын
Hi Bernie Thanks for replying. A drawing and parts list would be good thanks. lee@flightcaseuk.com