MicroBeast and Spektrum SRXL

[@johnblythe6453]

Some additional info the beast plus has to have its own battery as stated ,for the E.S.C plug this into channel 5 ail servo port, all other ports 1 to 4 are for servos-start motor as normal throttle up then down to calibrate . I had tried standard rx but could only get beast to work on SRXL .

[@Stan_Humphries]

Perfect video! Thanks so much Jim - saved me all kinds of agony.

[@pitchcurve]

Jim, Nowadays SRXL2 can just be connected on Microbeast Plus White side port (DI2). So, if I keep a 700 nitro machine, how can I connect the RPM sensor and my AR8020T SRXL2 receiver at the same time?

[@philralph7036]

A very clear video....thanks, but could you advise if this is the same for the AR6210? it dosn't have a SRXL port. many thanks

[@garylainey4689]

This video help me out so much greatly appreciated

[@sotheamam1244]

Hi. There, my beastx plus jump from L to H I and blinking orange back and forth and I can not get the heli off the ground and keep tipping. Any help 🙏

[@speedy5753]

Do you plug your Servos for pitch and Aileron and Rudder to the Receiver or Microbeast ?

[@v4zzy219]

Did you ever figure this out? I had the same question

[@tonyduong70]

hello, are u using a spektrum radio setup for this SRXL ?

[@chacenstacie]

What if you have a v3 microbeast?

[@MrBear1st]

when I power up A will flash but I don't get a status light at all, if I just power it up normally it will light up red, but lights c and I light up and after 3 seconds or so the front row of light flash left to right

[@black_baron_net]

☠BLACK BARON☠ "Made in Germany" ... can I buy a "Software Upgrade" for my FC6250HX flight controller as AR7200BX and AR7210BX seem to be discontinued in hardware and software engineering?

[@matejbludsky8410]

Would this work with DX6?

[@henkpipo4233]

yes

[@nealjag3917]

thank you

[@MrBear1st]

I must have the only faulty one ever made, pissed right off, been trying now for 2 days, had enough

[@henkpipo4233]

2020 saved my ass (L)