MicroFlex™ Abalone Shell Inlays

www.mudhole.com/
JL Leffler of Mud Hole Custom Tackle walks you through the setup and installation of new MicroFlex™ Abalone Shell Inlay Strips on your custom fishing rod.
--------------------------------------------------------------------------------
About MicroFlex™ Abalone Shell Inlay Strips
This all-new MicroFlex™ Abalone is remarkably thinner and easier to apply than previous Abalone products! Simply trim, heat up for a few seconds in a microwave or with moderate heat from a heat gun, peel and apply. Available in 9 colors.
Create stunning inlays and more with these hot new rod decorations. Sold in strips, approximately 4.75" by 2.75". Adhesive-backed and coated with a super fine lacquer finish.

[@JimEdmiston]

JL you're a boss. I'll be comin in soon to make an ultralight. I'll be sure to hit you up.

[@anoaiquiocho6160]

Music is on point!!! Reggae

[@JimEdmiston]

JL you're a boss

[@coosess]

Seems as though the seams didn't want to lay down. I would have just felt that it was worked through until I noticed that JL kept it from view by keeping the reel seat site away from the camera.

[@TonyGruber2009]

Hi, Can you tell me if normal rod epoxy can be used over this? Thanks, Anthony

[@Morgancj]

Is the abalone strips still available ?

[@MustafaKalafat]

is it real abalone? if not why label it as abalone?

[@MudHoleCustomTackle]

It is in fact real abalone shell. It has a EM backing to provide a strong adhesion to your rod blank.