Mid July setup info. Behringer XR18 EV/JBL system

Mostly so I remember next year. XR18 rack, EV ZX3 over JBL MRX518. 6 PS121 monitors (3 front, 1 drum, 1 float, 1 side fill). City runs power and owns stage

[@Shreevaibhavsounds]

Nice video

[@FOHFILMS]

How are your tops/subs hooked up? You said you are jumping from sub to top. Are the cables four conductor and the tops are using the second pair of conductors or something?

[@MrSamsstudios]

@@FOHFILMS correct, I use patch panels wired with subs on pins1 and tops on pins2. Four conductor cable to each sub and then there’s a special jumper cable using pins 2 on the sub side and pins 1 on the tops side. This only works in bi-amp situations, not tri-amp. Some of my speakers are biamp only (Triamp w subs) so the jumpers will not work but for passive tops it’s a nice shortcut

[@bfields112]

What model cvr amp are you using? I was told those amps only run on 220 electricity

[@MrSamsstudios]

90-240v, all amps will run on 110 but most can exceed 15a draw easy drive to max power. I chose the d1004 because it’ll only draw 19a 110v at 1/3 power (heavy clip) all channels 4 ohm. Still has enough power tho at 1000w/ch @8 ohms

[@FOHFILMS]

@@MrSamsstudios Where did you find that spec? I've been trying to find info on current draw for the CVR amps as I'm also considering getting a D1004

[@MrSamsstudios]

@@FOHFILMS I just uploaded a short with this info