Hey Dan, you're video's are really helpful. I recently bought a mig welder and I didn't have a clue in how to adjust the proper wire feed speed. All of these part1-part4 made me feel almost like a pro.
@WeldFever9 жыл бұрын
Carlos Gutierrez great, and thanks for the post!
@hxFubar9 жыл бұрын
Thank you for all 4, very informative can't wait to watch more.
@WeldFever9 жыл бұрын
+Fred Ubar Thanks for that and I hope to have new videos out soon!
@tonyciarleglio86517 жыл бұрын
Hey Dan I've got a question for you. I've got an old Airco welder that has 7 amp settings with speed control. The wire feed works fine on all amp settings and all speed controls except setting 5. When it's set to 5 the wire feed sounds like it should be working but the feed wheel doesn't turn. The liner is new the feed wheel is fine any ideas?
@arcturusbbqsausagemaking24357 жыл бұрын
Very Informative Im just getting started on Filming welding How to and shop project videos on KZbin can you please tell me what type of camera equipment you use to film your videos especially the welding puddle close ups I would appreciate any information you can give me .... Thanks
@Mmmyess8 жыл бұрын
Just a different perspective, here, on the wire end not going through the contact tip easily.... If the wire cutting edges of your welding pliers were dull, re-cutting the wire wouldn't have helped...you'd just get another bad cut. In my experience, what is more likely is that the wire end became slightly bent (or possibly deformed) as it ran through the gun liner, so re-cutting it gave a nice, crisp, straight end to run through the contact tip. Not a big deal, but I thought I'd mention it. Carry on...! :)
@issacvaldivia88847 жыл бұрын
Hey Dan, my wf2150 cambell haudfeld wire core does not turn? Do you know what it might be? i just got this welding equipment
@786malikhouse9 жыл бұрын
Hi dan I have watched all your videos and as im new to mig welding and im just going to set up my mig to straight co2 can you tell my how much pressure should I set it to please that would be very helpful thank you
@WeldFever9 жыл бұрын
786malikhouse 15-20 cfh is the standard and make sure there is no wind above 5 miles per hour
@raphiseguyan26809 жыл бұрын
good job
@WeldFever9 жыл бұрын
Raphi Seguyan Thank you
@jerrybeck88129 жыл бұрын
No videos for two months ? Where you been? You ok? Just wondering.
@WeldFever9 жыл бұрын
Jerry Beck Super busy summer, but I should be back at it soon. Thanks for checking in!
@mjkrigging63749 жыл бұрын
how come no new videos hope all is well
@WeldFever9 жыл бұрын
+MJK RIGGING Thank you for your concern. I am happy to say that I am doing well, but have been incredibly busy all summer long, and the trend seems to be continuing into the Fall. I hope to get some new videos out very soon though, so please hang in there!
@mjkrigging63749 жыл бұрын
+WeldFever good to hear busy is allways good
@WeldFever9 жыл бұрын
+MJK RIGGING Well, I finally made it back. Hope you have had time to check out my latest.