10M Rectangle Antenna

[@beerye9331]

I love your antenna build videos! Thank You

[@burnerphone7220]

I love your videos. Some of the best Amateur radio content out there. You sir are truly helping to advance the craft of radio.

[@mikesmuseum]

Matched great and less noise on that loop as well. Getting it elevated to that height is also a bonus. Well done!

[@youtubeaccount931]

Noticeably stronger 10m signals on the rectangle. Well done

[@acestudioscouk-Ace-G0ACE]

Wow, that's pretty good going and so close to the model! I've used the same program and although it's been good, it wasn't as accurate as it is here. A really nice antenna and I'm envious of your tall trees! My trees are 35-40ft but still worth a shot. I was interested to learn that a rectangle brings the SWR down. Thanks for the video Mike! 👍😃

[@frankartieta4887]

I really hate to speak of things so controversial as antennas BUT :) I once built a set of bi-square antennas for 10 meters Both on a single mast I am sure a bi-square has a bit more going for it than a 1/2 wave dipole I fed mine with 450 ohm line Well enough controversy for me I need to sign off :) TNX fer the great content You one of the very best in this genre 72

[@TheGmr140]

Video are great. TX antenna and a selection of rx antenna. 73s

[@BerrieSchuurhuis]

Nice video! It supports the videos by Peter VK3YE about oblong antennas. I've recently built them for 6 and 2m with similar success on a 12m tall Spider Pole portable setup. It seems like your approach is quite scalable for higher frequencies!

[@DAVIDGREGORYKERR]

Seems like the SIRIO STARDUSTER M400 will work on 28Mhz as it is designed to operate from 26.6-30Mhz but us tunable.

[@nathanhastings8293]

Basically it would be nice to know if there are roof lines or other places you could sprout an antenna (without erecting a moon-raker)

[@electronics.unmessed]

Nice antenna realization 👍and simulation 👍

[@chris_vk3radio]

Great antenna choice for performance and simplicity. If you're restricted in height a quad will still give good results where other antennas will not..

[@DAVIDGREGORYKERR]

Whatever modeling package that the DXCOMMANDER is using must be the right package.

[@_wave64_]

Nice!

[@W4TRI_Ronny]

Would you mind sharing the dimensions? I see it is center fed at the bottom. Thanks!

[@W4BIN]

They are ¼ wl on a side for a full wave antenna, for a square loop. Ron W4BIN

[@W4TRI_Ronny]

@@W4BIN For a better match though is there a ratio of one side to another for the rectangle? What did your top wire end up being in length?

[@MIKROWAVE1]

7.20 shows the dimensions in m and I convert to feet in the audio.

[@W4TRI_Ronny]

@@MIKROWAVE1 I watched again. It was a bit earlier than that but I see it now. Thanks! I'm going to run the top and bottom through PVC and secure it so it stays in shape and can be hauled up like a kite. Now that I have the ratio I can convert to any band for a starting place.

[@MIKROWAVE1]

Basically 6x12 ft

[@pharanchemie8645]

Thank you

[@jwdevine]

Your vswr is out of calibration on forward power. Measurement of the antenna's VSWR should prove to be lower than what you measured once calibrated. Timestamp 9:29 clearly shows power forward meter is generously showing output power of a couple watts with no power applied. The reflected power meter seems to be reading Zero as they both should. What you later claimed as 1.5 VSWR was probably really a couple of divisions lower... Where is the diddle driver in the desk drawer it's always hiding... 😂

[@nathanhastings8293]

I love antenna lore (hallicrafter sx-71)

[@clytle374]

So lucky with all the tall trees. I had to make masts, my wife is not impressed.

[@manueljesusmontielesquinar9068]

Magnifico vídeo.73 de EA7KKN

[@DAVIDGREGORYKERR]

What a Long Wire antenna which is 1 mile long driven via an 9:1 UNUN

[@migsvensurfing6310]

Nice result.....but no trees more than 5 feet tall here... Again you showed that a loop is a good choice (I also lov to watch w1vlf's channel, he is also great). Thanks.

[@DAVIDGREGORYKERR]

You have a perfectly good tree and could have taken a leaf out of W5JGV's book and got the tree resonant on 28Mhz

[@MIKROWAVE1]

You Nailed it! And then attached coax to the Nail!

[@Capecodham]

Old typewriter

[@MIKROWAVE1]

Ah yes something that Burton used back in the day.

[@G7VFY]

More antenna video's ! G7VFY

[@MIKROWAVE1]

I just put this back up for the sunspots and added 15M to it off the same feed. Works slick.

[@G7VFY]

@@MIKROWAVE1 That's great. How many bands can you stack? Do they have to be harmonically ..er.. related (Can't think of the right word.) 20-17-15-12-10m?