Рет қаралды 59,845
I finally got around to coding out the error codes that show up when upgrading the tail lights on y 2016 F56 MINI Cooper JCW from the circle lights to the Union Jack ones.
I use bimmercode (you should buy the full version of this app to support the developer on his awesome work!) and a vgate bluetooth ODB connector with my smartphone. Below are the steps needed:
1. Plug in ODB connector and connect via bluetooth to your phone
2. Launch the Bimmercode app
3. Go into the Front Electronic Module/Car Access System category in basic mode
4. In the voltage monitoring section, make sure the Tail Light Monitoring is set to LED and not monitoring
5. Change into expert mode
6. Go to the 3061 LcxOutputChannels2 section
7. Find and set BL_R_IS_LED = aktiv
8. Find and set BL_R_WARMUEBERWACHUNG = nicht_aktiv
9. Find and set BL_R_KALTUEBERWACHUNG = nicht_aktiv
10. Find and set BL_L_IS_LED = aktiv
11. Find and set BL_L_WARMUEBERWACHUNG = nicht_aktiv
12. Find and set BL_L_KALTUEBERWACHUN = nicht_aktiv
13. Now tap the code button in the app.
14. Your ECU may restart and your engine will shut off.
15. Power off the car.
16. Power back on the car and you should not see any errors!
Music by Joakim Karud / joakimkarud
Leave comments/questions below!