MINI F-Series Beltline Dechrome Kit Fitting Guide - SCP Automotive

Note: Please make sure the vehicle surface is completely clean before installation.
A fitting guide for the beltline dechrome kit, available at SCP Automotive.
Product Link: sherrattcustom...
Recommend Tools:
- Heat Gun
- Small Blade
- Squeegee
Fitting guide steps and their respective time stamps:
1. 0:09 - Measure the size of the beltline strip
2. 0:15 - Cut the piece that has been measured, allowing some room for error.
3. 0:23 - Leaving a slight overhang, begin applying the strip making sure the top is aligned perfectly.
4. 0:34 - Push down the beltline as you move along to apply the beltline. The vinyl tape will not stick unless pressure is applied.
5. 0:49 - Continue applying the vinyl.
6. 1:01 - On all corners apply pressure to push any fingers out of the vinyl. Pull the vinyl and reapply to avoid creases.
7. 1:25 - Any finger that you cannot push out, please use a heat gun to allow the vinyl to stretch and repeat step 6.
8. 2:01 - Heat up the vinyl and wrap over the end.
9. 2:14 - Make a crease to provide greater visibility of where to cut.
10. 2:20 - Apply pressure to the newly applied vinyl.
11. 2:27 - When the fitment is perfect us a small blade to trim at the edge, following the crease.
12. 2:33 - Peel away the excess.
2:41 - Repeat the steps shown in this guide, until the rest of the car is complete.

[@bird3010]

The guy in the vid has also clearly done it 1000 times makes it look easy

[@bird3010]

Just did mine, all the tips are spot on, however it would b great if the tape was a millimetre wider so you has room for error at the bottom, some points still have a tiny bit of silver showing and it’s hard to correct with the narrow tape

[@MillieonaVespa]

Nice job ….hoping to do this myself soon ..

[@scpautomotive]

Go for it! We have a few different colours to choose from.