Mini Projector Retrofit

[@lonewolfgamer81]

I have these on my 2000 Tundra in some aftermarket housings that luckily didn't have the reflector. Like them a lot.

[@JHBtheIV]

For the cost, they are definitely a noticeable improvement over the stock bulbs.

[@dirtnsmores]

Nice. The link seems to be dead for this product. I order the co-light mini projector from their website. Hopefully this works out

[@JHBtheIV]

Yeah, this video is older. They have probably came out with a newer version since I filmed this. Mine are still going strong with no issues though!

[@Ghost-xx3wb]

did you end up having any scattering issues. I just purchased an essentially identical set but im scared to go through with it since i would need to remove the shield.

[@JHBtheIV]

Not at all. You can see the beam patterns at the end of the video. Scattering issues are from using a standard LED in the stock housing, which is a bad idea IMO. Thats why I went with the collector (projector) type, so I wouldn’t have those issues.

[@drewwolfe6664]

Did you happen to have any issues with the bright light indicator on the dash not working after installing these?

[@JHBtheIV]

That happens when I unplug my fogs. There is not enough resistance in the circuit to “tell” the dash that the high beams are on. Add a resistor to the headlight circuit, and that should fix the issue.

[@cantu916761]

Nice truck

[@JHBtheIV]

Thank you sir.

[@jimmyfavereau]

thanks for the vid.. wet sand and buff those headlights and you will be one happy camper : )

[@JHBtheIV]

Sure thing. Yes, they are certainly due for another refresh.

[@pekp3k89]

hows the range compared to your old setup?

[@JHBtheIV]

Similar range, as I made sure to adjust them properly. They do put out better light though.

[@richmk3]

How did you Adjust the front head lights ?

[@JHBtheIV]

There is an adjustment screw in the projectors that allow you to turn the lense inside the housing. You adjust the housing itself the same way you would with factory headlight bulbs.

[@richmk3]

@@JHBtheIV I bought the same one . My head lights is facing up trying to keep it level,

[@JHBtheIV]

Make sure you have both projectors oriented the same way in the housings. I have mine with the open side facing straight down. That gave me a good beam pattern.

[@richmk3]

@@JHBtheIV ok thanks.

[@JHBtheIV]

You’re welcome! If that doesn’t get your pattern sorted, next step would be adjusting the housings themselves, using the adjustment screws in the mounts.