MissChanger - Dock v0.1

A Stealth Burner tool changer system for Voron 2.4 and Trident.
This project was inspired by [Stealthchanger](github.com/Ste..., [TapChanger](github.com/vie..., and [Voron-Tap](github.com/Vor....
GitHub: github.com/VIN...
Credit:
This project was inspired by [Stealthchanger](github.com/Ste..., [TapChanger](github.com/vie..., and [Voron-Tap](github.com/Vor....
Donate to the project:
Ko-fi: ko-fi.com/a_vinny
Paypal: paypal.me/NVoC...
BuyMeCoffee: www.buymeacoff...

[@brin8099]

Looks great. Very clever mechanism - haven't seen that before. Looking forward to seeing more videos of it printing and tool changing!

[@Slydog43UTube]

Looking great, can't wait to see more. Good luck

[@enosunim]

Great work! Hope someday I will do something similar to my Ender 3 = )

[@measureonceprinttwice]

In lieu of silicon mold, you can pour gasket sealent in a 3D printed mold, the same as you likely used to secure the bed heater.

[@winandd8649]

Very Nice! How many cm do you loose in Y when using this system?

[@vinny5915]

120mm. basically, 1.5x the Y dimension of the toolhead

[@winandd8649]

@@vinny5915 Ouch, that's way more than I thought.. I'm probably going to build an entire new printer to make use of the tool changer. I will increase Y with an extra 120mm, and probably X with the width of one cradle. (so I can house one more toolhead, plus being able to clean the nozzle at a low Z beside the bed making use of a purge bucket) Thanks! 👍

[@vinny5915]

@@winandd8649 the idea is that I can remove the toolchanger bit for the full built volume, if ever needed. kzbin.info/www/bejne/eJW5n5tjYrp-e9E

[@winandd8649]

@@vinny5915 Yes, I know, but that's not how I'm planning to use it 😉