Mitsubishi Evo X Performance Driveshaft Carrier Install (DSM03A0 - DSM04A0) - JXB Performance

Bolts holding the two halves of the carrier together - 20 Nm
Stud adapters hold the carrier to the car - 14 Nm
Red or blue thread locker recommended

[@ImJibby]

Nice! Super easy install! Just Preordered mine today!

[@CoLa411]

After you cut off the rubber bushing is there another bushing under it that stays on? Looks like you put the new bearing on the original rubber piece.

[@JXBPerformance]

We only trim down the excess rubber. The base layer of rubber that's molded onto the sleeve the bearing sits in stays on. That's what we clamp to.

[@3rik_3vo]

What did you use to cut the original main carriers off? Thx

[@JXBPerformance]

We use a "body saw" made by ingersoll rand

[@HaganeYoshi]

I really like these but 400 for them is way too much for me