Just a quick water run testing the new electronics.
Пікірлер: 69
@dilinihansika14835 күн бұрын
is it water proof???
@Violator-RC5 күн бұрын
@@dilinihansika1483 It is.
@SNKCreativity4 ай бұрын
отличная модель, купил себе тоже такую!
@Violator-RC4 ай бұрын
Nice. This is an awesome trail truck with lots of after market support.
@gustavoaraujo62783 ай бұрын
Comprei também, estou aguardando chegar 🇧🇷
@Violator-RC3 ай бұрын
@@gustavoaraujo6278 It's worth the wait.
@danielg.whjwjwjw55413 ай бұрын
Oi gente, sou do Brasil 🇧🇷 ! meu sonho é uma dessas eu sou apaixonado, só que aqui tá muito caro, vcs não poderiam me enviar uma de presente?
@giorbeau9 ай бұрын
can you make a tutorial of waterproofing using the superglue method on ur mn82
@Violator-RC9 ай бұрын
For the servo waterproofing?
@giorbeau9 ай бұрын
yes and also the electronics
@Violator-RC9 ай бұрын
@@giorbeau Sure. I'll make one.
@pearlborneo81735 ай бұрын
Pls. I will like
@pmilitary0472 ай бұрын
Can't wait
@pandacrawler6x65 ай бұрын
Nice Mods 🐼👍🏻
@Violator-RC5 ай бұрын
Thanks. I have an updated version of this MN82 on my channel you can check it out as well.
@pandacrawler6x65 ай бұрын
You're welcome my Friend ❤ I will watch 🎉
@Violator-RC5 ай бұрын
@pandacrawler6x6 Thank you.
@ElLicenciado5067 ай бұрын
Cómo le hiciste para que lo pudieras meter al agua?
@Violator-RC7 ай бұрын
Hobbywing 1060 ya es resistente al agua y el receptor para DumboRC, usé esmalte de uñas y el lipo 3s está envuelto en globo de goma y el servo de engranaje metálico DSpower también es resistente al agua, pero usé superpegamento en las costuras solo para estar seguro.
@isaacrios44244 ай бұрын
How did you attach the stock wheels to the rear window like that?
@Violator-RC4 ай бұрын
I used a zip tie.
@isaacrios44244 ай бұрын
@@Violator-RC what suspension?
@Violator-RC4 ай бұрын
@@isaacrios4424 on this video it's still using the stock suspension. Here's the update build. kzbin.info/www/bejne/joGkemNjo7WbnsUsi=CN_u3-bozSnXDifL and kzbin.info/www/bejne/joGkemNjo7WbnsUsi=CN_u3-bozSnXDifL
is the stock mn82 waterproof ready? or do we have to purchase a certain part to make it waterproof?
@Violator-RC2 ай бұрын
@@kyusha5122 you have to use nail polish on the electronics ro make it water resistant.
@kyusha51222 ай бұрын
@@Violator-RC ohh ok ok do i need to extend the antenna from the circuit board? or just put a nail polish too on that short antenna?
@Violator-RC2 ай бұрын
@@kyusha5122 no need for the antenna.
@kyusha51222 ай бұрын
@@Violator-RC ohh ok... coz i saw a post about the mn82 getting submerged under the water and the rc stopped working although the board is waterproof it says the antenna is too short and its way under the water and stops working but after removing it from the water it works again
@Violator-RC2 ай бұрын
@@kyusha5122 If the antenna is submerged underwater then the signal is going to drop. I thought you meant putting nail polish on the antenna :D
@desertleo42974 ай бұрын
What wheels are those?
@Violator-RC4 ай бұрын
I'm using the Alf extreme tires on this video. You can check the updated build here. kzbin.info/www/bejne/joGkemNjo7WbnsUsi=bSWxodnIhTvP3sQj and here kzbin.info/www/bejne/l3nMiJdmrZ6UbLssi=GUoMaG2kfoFgz23J
@Abdulrahman_T7475 ай бұрын
Today I took it off-roading in the beach but it fell in the water half of the car was covered and it starts moving by itself can you tell me why?
@Violator-RC5 ай бұрын
Did you waterproof the electronics?
@Abdulrahman_T7475 ай бұрын
@@Violator-RC no
@Abdulrahman_T7475 ай бұрын
@@Violator-RC is there a way to fix it or not because I’m letting it dry rn
@Violator-RC5 ай бұрын
@@Abdulrahman_T747 You can try to turn it on again once it completely dries. Dry the electronics and the battery completely. But in case the electronics are fried then you have to replace the electronics by buying a esc and a Rx/tx
@Abdulrahman_T7475 ай бұрын
@@Violator-RCshould I buy a new mn82 the beige or lc79 the red because I can’t find where to buy the Esc and the rs/tx
@rafiqinherman87187 ай бұрын
you used 280 motor?
@Violator-RC7 ай бұрын
Yes. On this run it was using the stock 280 motor on it.
@AlexBodrovFamily6 ай бұрын
Are those stock tires ?
@Violator-RC6 ай бұрын
Nope. Those tires are Alf Extreme tires. You can check the updated build on my channel. Thank you.
@BulbBunny9 ай бұрын
Did you waterproof it
@Violator-RC9 ай бұрын
I'm using HW 1060 and dumbo rc tx/rx and 3s lipo on this run. But I tried running the stock electronics with nail polish and never ran into problems.
@reyjr36089 ай бұрын
@@Violator-RCI'm new in this hobby..may I ask,what should I waterproof it,and what I shouldn't waterproof it..thanks
@reyjr36089 ай бұрын
Doesn't the tires a bit too big? Won't it stuck when cornering?..what tires did you use here..
@Violator-RC9 ай бұрын
@@reyjr3608 I trimmed the fender a bit to make sure that won’t happen.
@Violator-RC9 ай бұрын
@@reyjr3608 The stock electronics on it should be waterproofed, you can use nail polish to achieve that. You can also water proof the servo by using superglue on the outside casing where all the lining on the servo case should be.
@danielg.whjwjwjw55413 ай бұрын
Oi gente, sou do Brasil 🇧🇷 ! meu sonho é uma dessas eu sou apaixonado, só que aqui tá muito caro, vcs não poderiam me enviar uma de presente?