MO-1000 Introduction

[@kayphuff]

I have two issues. Using the looper threader for the lower looper. The wire does NOT come out anywhere. Secondly, getting the foot ON is difficult to put it mildly. If I have the groove aligned, the wire on the foot will not set in it's groove. If I align the wire first, then the grove does not align. When I finally do get things aligned I have to use my tweezers to push down on the foot to make it snap into place. Hope you have ideas on how to fix these issue for me.

[@sharonpeugh1558]

I just received my new Juki MO 1000, purchased from Amazon. I set it up, threaded ut and tested the tension. The machine is making a very loud noise when it sews. What should I do?

[@ernestinacastelletti9340]

quanto costa

[@sharonphilpott6538]

Very informative, but I couldn't get to the end because of the brainwashing music. It drove me nuts!