MOCK INTERVIEW FOR ANALOG PROFILE || By Himanshu Agarwal

Book 1:1 call with me for mock interview, preparation strategy, resume review etc. - topmate.io/himanshu_agarwal
Course on Basic Electrical Science for placements - himanshuagarwal.graphy.com/co...
#GATE #TI #NXP #intel #synopsys #qualcomm #ti

[@HimanshuAgarwal_]

Update (27 July) - Advait has been selected as an Intern in Texas Instruments. Book your mock Interview - topmate.io/himanshu_agarwal

[@StandforAjdetray]

Vout(t)+Vc(t)=0 so Vout(t)=-Vc(t)=1/c integral from 0 to t on( Iin(t))dt thus Iin(t)=vin(t)/R So Vout(t)=-(1/RC) integral from o to t on (Vin(t))dt this formula is correct until you reach the negative supply voltage ,thus you have -Vcc in some place 😊

[@mdtariqueali1262]

Excellent initiative

[@amitjana8172]

Nice video Dada,

[@arnabseth7800]

Bhaiya could you post another one of these interview videos but for fte (if difficulty level is a little bit more for that), and a little bit more focus on MOS ckts and other non-standard questions from RC and opamp (if any apart from voltage current waveforms)? The videos are of great help, thanks!

[@kaustavguharoy4532]

For problem 30:37 There is an intuitive method with which we can find the zero of this system , Step 1: swap Vi and Vo terminals (now T(s) = Vi/Vo = (s+z)/(s+p) = new T.F ) Step 2 : ground Vi and find the time constant (= RC for this ckt )

[@KK-bj3mq]

Nice video,

[@akhilmalladi2463]

Sir when is the course on analog electronics coming ?

[@ankitsingh-rc3jh]

Bhaiya how to make a PI(PROPOTIONAL INTEGRAL CKT) FOR PROJECT

[@sumanbaur3021]

At 44:00 I think the waveform of Vo will start from origin and after t1 it will be saturated. Am I correct?

[@pawanpangapawan3341]

Hello sir how to register for this mock interview

[@samudravishalmukherji7329]

can we expect similar questions for new college grad positions also?

[@sanketkumar1958]

i have a doubt, in question no-7 for finding capacitor voltage at t-infinite ,you have taken i=0(current through the opamp) ,but as V- does not have same voltage as V+ ,i cannot be zero. can you clarify ,will be of great help

[@ranjith8869]

This is for layout profile or circuit?!

[@harshithvishwanathan4419]

pls give video resources to where to study from

[@amitjana8172]

In analog and network I almost covered all the topics which you have mentioned in the previous video. Is there any topic in signal system that I need to study for FTE at TI?

[@HimanshuAgarwal_]

Fourier series, Fourier transform

[@praveen9964]

Analog ka course kab ayega ??

[@ariyansardar9029]

dada is there any course u r going to launch before TI comes ?

[@HimanshuAgarwal_]

Will try to

[@PJ-Digitallearn]

Bhaiya aapka mobile number milega kya