Model Builder inLab SW22: Working Model Workflow

[@MuratAktaş-k3l]

When I do the ball joint supports, where am I going to find the piece in between to use it as a articulating model(Is it something that I can buy or print ?).If there is not, I don't get the point adding ball joint supports.Thank you

[@digitaldentistrysolutions3158]

Yes, absolutely! Several distributors sell the disposable components for the ball joint articulator. Typically I’ve seen it in a package of about 25. I’ve seen them sold through Zahn before. But I know several others carry them as well.

[@ArnoldKang-t3n]

can you also design implant models?

[@michelleglover3856]

You bet! When a DS scanbody is present, “create analog” during the design phase will become available. In most countries you can then choose from either NT trading or Elos analogs. :)

[@shoplocalam9158]

Is there a way to create a model ditched around the margin without a removable die? Thanks

[@digitaldentistrysolutions3158]

Absolutely! :) when you’re in the step to create stump, you can select “create ditch” but deselect “create die”. This will then create a ditched margin without the removable stump. Hope this helps!

[@shoplocalam9158]

@@digitaldentistrysolutions3158 ok, seems like that works in SW 22 not in 20:(

[@digitaldentistrysolutions3158]

Same could be done in version 19 and 20. What region is your software running as? Mine is canada, and I’ve been able to do that since version 18 or 19 when model builder came out.

[@shoplocalam9158]

@@digitaldentistrysolutions3158 Region is Germany. I got it now, i had the spacer reduced to 0. If you uncheck create die you cant change the spacer. So I checked create die again, made the spacer higher, then unchecked creating die again and it works now. Thanks a lot!