Morini clutch assembly pt2

[@bluescargo]

Thank you very much Paul for uploading those veri nice detailded and helpfull videos.

[@EVguru]

Nice to know that they're being appreciated.! I may re-edit this one a upload it again.

[@eskileriksson4457]

Paul Compton I was thinking of the kick-axel and the seal on that. I'm not sure, but I don't think you mentioned it?

[@NewArtSchool]

Hello Paul, would it be possible to get the specs of the white tapered sleave that you use on the input shaft? I recently tried to install without a tapered sleave and I must have nicked the seal. Didn't go on as easy as I thought it would and now I have it to do over. Thank You for all these video, always end up coming back to them.

[@EVguru]

The outside diameter matches the clutch sleeve/bush and the inside diameter is a slip fit over the input shaft. Then you just need a bit of taper. There is a drawing in the "Blue Book" workshop manual, or the Engine manual (published under Cagiva ownership).

[@mesh2491]

Hi Paul - you mentioned that you get your gaskets from Athena. Do you get them direct? because their website only seems to mentiond brake pads and emailing din't help either. Thanks, Guy

[@EVguru]

www.athenaparts.com/eng/models/view/10332/moto-morini-4t-350-s-gt-canna-ghisa