Morris' Mini Motors way of doing CDI TIMING on Single Cylinder Engine

[@SommerAdric]

Ooo now you can do the same video but for radials 😁 please!

[@173shatta]

Soon!

[@windsurfingphd]

Good video, but I am a little confused how you found TDC. I usually open up the valve covers in 4-strokes to find the TDC in order to make the valve adjustments. In this case, I would adjust the piston stopper from the valve lifters' motion to make sure I am at TDC, and go back 30 degrees BTDC to align the Hall sensor with the magnet. Please let me know if I am mistaken. Thanks.

[@piusjob3576]

You mentioned that there are Hall Sensors connectors with 3 Pin for single Cylinder, and Connectors with four Pins for Radial engines. What is the difference. Any Hall sensor has always just 3 pins. Are different hall sensors used for radial engines?

[@PhilipAlonzo]

So we can buy from morris mini motors and you guys can break in motor ?

[@R.B_B]

Nice. With four stroke and two srtoke engines conversion. I need the CDI with 90 degree or 120 degree?

[@173shatta]

All depends on what make of engine do you have

[@R.B_B]

@@173shatta I have One YS 120, saito 100, Os 95sv and ASP 120.

[@173shatta]

@@R.B_B 120 degree Cap

[@R.B_B]

@@173shatta Nice. Thank's