Motion Sequence Error on NeoDen4 Pick and Place Machine

[@ibrahimmousavi]

Hi we have same problems , how we can solve that?

[@sprucescience]

We tested each feeder and peeler individually by manually advancing them several times under the "Manual Test" tab with the "Feed Peel Synchronous" box unchecked. During the test, we discovered that one of the feeders was not responding. We unplugged the malfunctioning feeder and noticed that the feed-box feed error disappeared. After removing the problematic feeder, we retested all the feeders with the "Feed Peel Synchronous" box checked and found that they were functioning properly without any errors. We tested multiple times on each feeder and did not encounter any issues. It seems that the malfunctioning feeder was causing severe problems and causing the software to hang. Removing it appears to have resolved the issue, but we are unsure of the cause of the problem, whether it is with the feeder itself or the software. What are you currently working on?

[@ibrahimmousavi]

@@sprucescience We had defined two nozzles in the pcb information section, but in the feeder setting section of the aply section, 3 nozzles were ticked, and we apparently solved the problem by removing the extra nozzle.

[@ibrahimmousavi]

@@sprucescience We are also having this problem recently where we are having a problem with the "photograph is faild" box, do you have a solution for that?

[@lovesick3933]

​@@ibrahimmousaviHello İbrahim, I am getting the "photograph failed" error, how did you solve it?

[@mjsilvarivas]

@@lovesick3933 Hello, I have a 3V-Adv and that error (Photograph error) appeared when the cables of the camera (USB) where loose so the computer doesn't recognize it anymore. Additionally, random miss placing error where produced because of a faulty connector on the stepper motor that rotates the nozzle. In summary: Whe soldered the cables directly to the cammera (down looking), changed the USB port of the uplooking camera (inside the machine), replaced the faulty connector on the stepper motor. I know its a little bit older the question, but I believe someone will found it useful.

[@ifmatos]

I have a Neoden 3V. It is a buggy machine. Without reason it will corrupt file that was working perfect and make a mess .. That machine is a waste in of time and money