Fixing A Sideswiped Chevrolet Silverado In 8 Hours!

in todays episode I do the body work on this chevy Silverado! Hope you guys enjoy
Instagram:
www.instagram....

[@FlyEaglesFly19111]

Great job.. Yuri doesn't like em either..😅😂😅😂. ..Stay safevand be well. God bless

[@caseyspeer8179]

One of the main reasons I love watching you is because your work is honest in your fair and honest with the customer and the job is going to get done right and maybe one day you'll have your own shop just like this

[@tomswindler64]

Very nice,you’re killing it.getting better and better on your techniques.be safe 👍👍👍😎😎😎😊

[@basscomander6348]

Digging the music selection

[@joanwilliams3221]

You guys always do good work 👍👍

[@_Haris1904]

Can't wait for the M3 to be rippin down the streets

[@JenzRock]

Wicked. Ripping through stuff.

[@johndemeen5575]

Just wondering, if it rained there from that storm? St.Paul,Minnesota.

[@deebee3901]

Loving your repair content mate!

[@stephencarter1442]

Good Morning Hotrod time to make coffee. Sweet!

[@SunShyne_Culture]

You do great repairs. Love watching you from your dad's shop and your M3 ❤

[@robertjones2208]

Looks amazing, nice follow up on the Corrolla.

[@Motorheadco]

@@robertjones2208 yessir 👍 next episode is a follow up on ram and this one as well as another project 😄

[@bobbyjay75]

Love your work Marc. I could work with you. Yuri too. Ben no. lol 😂

[@skinnerhound2660]

Go Marco go! See you next week.

[@johngrant1337]

great video thanks

[@carlosvelez4680]

Another great job…

[@marc5460]

tnx for the video

[@theneoncanary]

Nice work!

[@patchmack4469]

i am surprized you dont use a lift to remove the rear tub, i mean i work alone a lot, and use a fork lift so its easy, but when you have four people lifting, no is looking below incase a wire snags or something - even an engine hoist would do if you make some chains hooks to latch in on the tie down loops etc, would be real easy to rig and cirtainly save those minor imbarrassing moments great work Mucky Marky and Viktor

[@Motorheadco]

@@patchmack4469that would be nice haha and thank you !

[@laptopuser3323]

Gday mate

[@Crazycarlisle]

FYI : you don’t have to replace all those little metal clips on front fender. You just squeeze them with pliers and when you run screw through them again in place they open back up and hold .

[@Motorheadco]

@@Crazycarlisle I know it’s just annoying swapping them lol

[@Crazycarlisle]

See if y’all can pick up a good used pro spot or Car-o-liner spot welder it will speed up all your jobs when replacing panels .

[@A01-j9n]

How did you get insurance co. Pay for a complete bed side?

[@tonyc9260]

Hows Ben I haven't seen anything new from him for sometime I hope all is well

[@marioen4716]

I like your work. Saludos desde mexico