Can you post the video showing dismantling of standing light pole in the same way, without using any other machine such as man lift to hook at the top?
@x91s552 жыл бұрын
Dismantling a standing pole is basically the same way. You just pull up and gently put it down and move the boom out to lay it down
@stephanmenzies19272 жыл бұрын
I can show you a much easier with same machine. 💯
@tumedisomofokeng24584 жыл бұрын
why not use a crain with a clamping hand
@Chrisdian74 жыл бұрын
I wonder how to take out the sling after pole erected
@countryhick10114 жыл бұрын
the half hitch will slide down the pole when tension is off
@subhashsaini15065 жыл бұрын
Pole hight in feet
@DelScorch03 жыл бұрын
Wow, took them over 8mins to erect a 30 foot standard? The pole material looks aluminum, even steel isn't heavy enough for a 19T stinger crane that is not the right crane for that job. Its way to slow if you have to rig a line to the base. Just pick it up from the top with a tag line and unloose the sling after bolts are torqued.
@martinpoel3 жыл бұрын
The pole is galvanised steel, the objective of the excercise was to test the grabber crane as it can still erect a pole while it is windy
@justinpack26105 жыл бұрын
if the pole kicks out the man standing sitting at the base would be injured why are they not using a tag line.
@martinpoel5 жыл бұрын
I am not sure, these people have been lifting these poles in this way for the last 40 years, I have not heard of any injuries because the pole kicked out.There is another video that shows a pole being installed with a grabber device to lift the pole, that looked at the time very promising and I have noticed it being used on some recently completed roadway lighting, here is the video showing both methods kzbin.info/www/bejne/e5madJuseqd3hNk Regards, Martin.
@elmasbuscado9094 жыл бұрын
I always pick it up fron the mast arm with a sling
@stephanmenzies19273 жыл бұрын
How would it Kick out? They half hitched the lifting strop at the top of the pole. It should not kick. Personally I would do it much different cause when they put it down on the flange it was not flush which would make it more difficult too tighten the bolts to the flange stud.. other than that it was a very simple and safe technique.