MS400 and 2511 Clone Cutting Up Some Locust

[@clintbliss2046]

All the paint gone around the edge of your bar can be a lack of lubrication. It's getting hot.

[@illnaturedsaws]

@@clintbliss2046 It’s a really old bar. The 400c doesn’t have the best oiler either. But it’s still true so I’ll keep using it until it breaks. haha

[@clintbliss2046]

@illnaturedsaws I think there's a upgrade oiler for the long bar on a 400

[@illnaturedsaws]

@ My bar gets plenty of oil. It’s just old and probably had the oil holes plugged a couple times when I was using it heavily. I widen all the oil holes on my bars. I also run it full throttle a few times before I start cutting to make sure the bar has oil. For how old the bar is and how much I’ve used it, the condition is surprisingly good. I switched to D&G bar and chain oil about 6 months ago and it’s made a huge difference on the life of my bars. My 32” Stihl bar has very little noticeable use on it and I’ve used that bar to cut timber out on the coast. The bar I’m using in this video was the second chainsaw bar I ever bought.