Msfs2020 *G1000Nxi Lean Assist* Full tutorial-POH/Power cruise settings and much more!

Hello everyone hope you are well sorry again about the darn mic it was to close again i hope that next video i have this ironed out now im using feed back so i can hear myself so this doesn't keep happening. Anyway we go over the lean assist feature in the G1000nxi mod for microsoft flight simulator 2020. I also explain some terms used in operation of the lean assist and how to properly set the fuel mixture in any plane. I have also provided power and cruise settings below there are 2 links for that. I am also using the bonanza improvement mod links for that down below as well. At the end of the video i discuss how to properly set the best economy power setting as you cannot use the lean assist feature to do this and i go over why in the video but i show you another way to do this more of a manual way of doing it but it works. So if you have any questions please leave them below and make sure to hit the subscribe button and like the video. Thanks for watching.
mycfibook.com/... Some good info to read
www.cfc1939.org...
This is the power setting for the a36 and they work fine with the g36
• Msfs2020*Community Dow... An easy way to get the bonanza improvement mod and more!
For custom VR lenses Check out this link and use the discount code to get 5% off your order! www.vr-rock.co...
5% discount code: 2020fsers
Check out our facebook page / 1081420896026970

[@brentsnoddy1951]

Just ran across this. I thought I was using the assist correct but I was not doing the reset as you showed. Thanks again. BTW has anyone on the comments indicated the units of measure error of inch pounds versus inches of mercury manifold pressure. lol Thanks again for the great info.

[@2020fsers]

your welcome thanks for the comment

[@MattBarraud]

Great video! Stoked to see the Improvement Mod! :-) CaptMatto

[@2020fsers]

It is very nice I love it 😀 😍 thanks for the comment

[@CaptHawkeye]

This was such a great video. This will help me a lot.

[@2020fsers]

Thank you for the compliment ☺️ glad you got some.good info out of it.

[@Damgot]

It seems it's no longer working with the new avionic update. EGT doesn't change when you lower mixture (except if you put it to 0 because the engine stopped 😅).

[@2020fsers]

Great another thing they messed up lol. If you don't use lean assist does the egt temp change when you adjust the mix? If so you may need to manually watch it instead of the assist feature

[@Damgot]

​ @2020fsers Since my message, I've asked the question on MSFS forum and it was just the automixture that was activated... I even didn't know about this option. My bad ^^

[@2020fsers]

Oh yeah in the assist option I keep all mine off

[@poker8193]

Yea mine didn’t change burn rate or egt unless you go full lean and engine dies

[@FU2Max]

hey 2020 Brilliant, thanks very much for this tutorial!! now i understand :o)

[@2020fsers]

Great glad to help thanks for the comment 😀

[@Glicksman1]

Where is the manifold pressure gauge?

[@2020fsers]

It is in the mfd top left gauge .

[@2020fsers]

On the g1000

[@Glicksman1]

@@2020fsers Thank you.

[@2020fsers]

Your welcome