My Iron Man Project! - Update #02

Update #02 - Arms
One step closer!
Got some stuff printed so let's have an update!
I'm Stefan The All-In Nerd and this is my Iron Man project!
I have to get it finished before Comic Con - Stockholm in November 2023 so there is a deadline!
I'm aiming for movie-accurate with some adjustments for mobility.
I want to make it quite motorized so I'm really looking forward to learn and build all that!
Here's the teaser for it if you missed it: • The Iron Man Project!
Check out my live-streams on Twitch for a fun time!
Twitch: / theallinnerd
Instagram: / the_all_in_nerd
I hope you enjoyed the video and Like and Subscribe if you did!
Until next time!
Pew pew!

[@WarrenPenner]

Loving this series! Good stuff here!

[@Cziro_]

Dayuum! I can't wait to see it done and than filled with lights and stuff :D

[@TheAll-InNerd]

Same here! I hope I can make it justice! 😅

[@STRB909]

If you dont got a dual drive gear extruder it´s hard to print with flex. It´s easy to uppgrade and all prints get better result.

[@TheAll-InNerd]

Thanks for the tip! I need to look into that then! 😁

[@runklestiltskin_2407]

You will need to dry the flexible filament before printing

[@TheAll-InNerd]

Alright! Good to know! 😁 Oven ok or better with a proper filament-dryer?

[@runklestiltskin_2407]

@@TheAll-InNerd depends on the oven and how good it is at not melting the roll into a puddle shaped block, I use a food dehydrator. And be careful with bed adhesion, TPU 95A from Esun sticks like crazy to smooth PEI, I use a textured powder coated PEI spring steel cold.