BMW M52tu M54 NEW STYLE Coil Pack And Valve Cover Upgrade

[@kevinwalsh4]

If you have the entire m54 coil harness its plug and play if you swap to the m52 connector with the brown wire and red/white wire. Just my .02

[@davidj4662]

Nice job. Watching you has given me confidence to do my own service and small repairs on my E46. You saved me lots of $ and misery at the BMW dealer. Although they do have “free” coffee.

[@RobertMPage-py2vv]

Good video. After watching it a couple of times, I did the same thing last weekend on my old E53. I will repeat this on my E39 next month..

[@brianandrews7099]

Aways a huge load off after they start and run for the first time! Good job!

[@glowsite2088]

I had installed brand new coil packs. And now im getting misfire detected in cylinder's 3 5 & 6 initially had misfire detected in cylinder 4. So i bought new plug thinking it would correct issue. It however, carried over into the ones herein listed above. What am i possibly missing here ?

[@justeffingaround2103]

03 325ci with push coils.... Swapping a 3.0 with bolt in coils.. Am I able to swap over my 2.5 valve cover and just use my push coils and all stock wiring then? Thanks for your help

[@daleyurk4369]

Good job Nathan. Would have liked to see one coil conversion in regular motion and close up. But still, enjoyed your stuff as always. Hang in there!

[@jetstreampropulsor]

Nathan, thanks for all of your hard work posting these vid's. I have been searching for a used e91, heaven forbid, and I stumbled across your channel. Your experience is invaluable, and your generosity inspiring, and reassuring. Rare commodities these days. It's nice to see human's working together to make life a better experience for one another, instead of whatever else is going on out there!? I live in London Ontario, yes Canada, so some of the U.S. part sources may be a little tricky to deal with. You offer a great wealth of knowledge to reference any time I may need some moral support. Keep up the good work!

[@FoolishPursuitForce]

Hmmm, I am getting the primary resistance error having done the same change.

[@jamesluke7377]

I must have missed something here... Which valve cover are you using for this upgrade? An m56 or a valve cover from a different engone? Bueller? Bueller? Bueller?

[@riverkcarolina]

James Luke the aluminum valve cover used here is from a 325i SULEV engine.

[@zerotohero7449]

Are the new style coil packs better than the old style?

[@glowsite2088]

Im not 100% sure upon old vs new coil packs being better. I think with this conversion you may need to swap fuel rail to possibly.. Check your fuel pressure what psi its putting out in bars.. 2.5 bars for example is say 45.2 which is right on target of bmw spec meaning fuel pump to fuel rail is doing its job so no issue there.

[@tracyphillips3325]

That went really well. Getting closer.

[@ricklane8554]

Wow man... you can work really fast!! Loll.

[@raitshots]

No bad