Navi Dual-flash fix | Diode Install

[@ricktaylor26]

You explained it much better than others have. Good job . What did you need to do to get the back turn signals to work ? If anything Thanks

[@pookythomasmoto9147]

@@ricktaylor26 the left side and right side turn signals run off the same switch. So if the front is working the rear should work on the same side. You may have a wiring issue

[@JayKing-tj2et]

having the same exact problem thankfully i finally found this video of your, i only need to buy one of these yoshi diodes not 2 pairs correct?

[@pookythomasmoto9147]

@@JayKing-tj2et just one like I used in the video

[@xCARPx2014]

Where did the black wire come from?

[@kc1800party]

thanks for being a great honda navi resource, i appreciate it. quick question: what did you connect the ground to? i have to use the frame since i don't have a spare ground just chillin

[@pookythomasmoto9147]

@@kc1800party there is a bolt that holds the headlight bezel frame on. It’s an M6 and I took a battery terminal connector and linked the wire to that, and then threaded the bolt through it

[@kc1800party]

@@pookythomasmoto9147alright i think i know which one you’re referring to. thanks bro!

[@kc1800party]

@@pookythomasmoto9147 my bad bro, i just rewatched the video. my dumbass didn't get towards the end which would've answered my question haha. that was exactly the bolt i was looking at too. thanks again.

[@benny7706]

Hey, what kind of tires are those and where did you buy them? Can you leave a link?

[@pookythomasmoto9147]

Shinko whitewall 723, amazon. 110/70-12 both front and rear

[@kevinzolabarrieta9865]

Hello, how to place the S2 LED there ?

[@pookythomasmoto9147]

@@kevinzolabarrieta9865 that was a custom bracket I made of amazon clamps

[@kevinzolabarrieta9865]

Could you show me which clamp it would be?

[@lesnielaguilar9504]

Miro que es facil y segun yo era complicado pero con este video lo hare mas adelante