NEW Aqara motion sensor with Matter over Thread

[@donpowers6033]

Eric, one thing I do not recall you mentioning is that the P2's light sensor is exposed to HomeKit unlike the light sensor in the P1. I think this is a game changer and could make it worth upgrading.

[@EricWelander]

Good point!

[@Jozone86]

Exciting product -- I have been waiting for one that doesn't have the hub dependency.

[@a_d_s5361]

Do these and previous Aqara motion sensors have the ability to trigger a HomeKit notification on my phone when they detect motion?

[@EricWelander]

Yes they can. Under “Status and Notifications”

[@USRMBMN1]

I don’t use the Aqara sticky pads., I use the 3M Command hooks (poster strips) instead.

[@AhXiangMahjong]

Can this motion only be activated during specific timing ? Example only nigh time

[@HakonJohansenKampen]

Is this controllable directly through google home script editor? Specifically using the device.event.MotionDetection event starter?

[@MrAgility888]

Are there any matter compatible leak detectors you recommend?

[@EricWelander]

Not that I've tried yet

[@Travis.865]

Looks like the P2 is no longer available in the US. The Amazon page link to the P2 no longer works. Any word when it might be available again?

[@theweejr]

Hi am trying to use motion sensor to control my bed room light that if they detect movement light should be on and i use scene good night to turn off all light then if i wake up in the dark and move my body the light will turn on is there any solution for this problem

[@Mindcrawler23]

The most important question before i consider any sensor from Aqara: Will they finally be fully compatible to routers from other manufacturers? In the current situation, risking stability by adding Aqara devices to a non-Aqara mesh doesn't seem like a smart idea. And no, i'm not going to spam my house with smart plugs i don't even need, just to make the Aqara sensors work.

[@djLovelyTime]

Your audio is too loud

[@PepperoniBiscuit]

Bad review by quickly glossing over/subduing the fact this cant be used in the Aqara app, nor connected with current Aqara hubs.

[@richardgarno6591]

That point was clear to me.