New front indicators for the Triumph Bobber. Full installation video

[@Solroper4461]

Great video, Kellermans look a lot neater and brighter, better look altogether. 👍

[@britishbobber]

Thanks appreciate it 😁 I agree with you they are impressively bright for their size

[@garethclark7557]

Hi, I followed your video but I'm finding then LH side indicators is loose no matter how much I tighten it. Arenyou having the same issue please?

[@britishbobber]

Thanks for checking out the video. I haven't had problems with the LH side. If it's really loose and moving when riding maybe you could try some lock tight/ plumbers tape or similar.

[@Solroper4461]

Did you have to fit any resistors?

[@britishbobber]

I haven't fitted any

[@Solroper4461]

@@britishbobber I had to fit a resistor, the flash rate was too quick, even tried all the settings, sorted now though.

[@britishbobber]

Oh did you. I haven't noticed that on mine.. what resistor did you use? This is news to me and really appreciate your advice

[@Solroper4461]

@@britishbobber I used a kellerman I load resistor.

[@TheChrisglasgow]

Stock lights are horrible. Even the staff at my triumph dealership agreed with me last wk when I said I wanted them swapped out b cos they are ugly. I got them to install kellermanns under my seat attached to seat pan looks nicer than putting on frame of bike and it hides all the wires as well.

[@britishbobber]

Agreed they are so big and clunky. Are you talking about the rear indicators under your seat? This video shows the front indicators under the clutch and brake lever.

[@MrEye4get]

So tiny! The video is easy to follow.

[@britishbobber]

They are very small but still give out a lot of light. Thanks hope it helps. Will you change your indicators to them?

[@vivianfoster6534]

Its a good video understood everything you said but I did not like the wiring work you did you cut the slip connectors off one set of wires and left them on the other set of wires you should have cut them all off and heat shrink them and heat the other two wires together over the other two wires that is coming out of the indicators I could not live with all that tape sorry. It will be just a matter of time before the water works its way into the tape ask me how I know I ride a Rocket GT and I will be buying the same indicators you have I hope you do not mind my criticism kind regards viv

[@britishbobber]

Its not a bad idea to do it your way. I didnt have a heat gun so discounted the heatshrink. I do like the idea of cutting the slip connectors off the stock indicator wiring though it will make the wires a bit thinner. Disagree with the water getting in. I wrapped those wires nice and tight and neat plus water can only get in if you ride in the rain... I have no intention of riding in the rain 😅

[@vivianfoster6534]

Going to watch your fender one tonight

[@britishbobber]

@vivianfoster6534 oh good... I'll brace myself for all the ways I should have done it better

[@jeffv4728]

@@britishbobber 😆