NI myRIO: Rotary (quadrature) encoder

[@brunocampera299]

That's quite a class! Thanks!

[@Denvermorgan2000]

Thanks I was struggling to understand this.

[@captain_bretzel]

Very useful, thank you!

[@stormtrooperelite1453]

Really good video. Is there any document that shows practical bounce time for a Bourns PEC11R series. I'm debouncing it from an FPGA board and (so far) I have specified a 5ms bounce time which seems a bit too much right now

[@ntspress]

Stormtrooper Elite Maximum bounce times are not often quoted because the way in which the user closes and opens the switch can vary widely, e.g., amount of force, speed, etc. Ideally you would use an oscilloscope to observe typical behavior of your specific switch, but if that is not possible you can simply try different values until you are satisfied with the reliability.

[@martyang705]

But Mitsubishi Motors.，A and B,i can not see the Waveform in the Oscilloscope

[@khounslow]

Many thanks!

[@JulioZaga]

Thanks....