Support Arm Build #7

[@apalmer47]

This must be one of the longest builds I have seen you do.

[@kevinhamling1963]

G'day Mr Nik. Your almost there and I'm certainly not an expert but your welds came up looking good. Anyhoo thanks for sharing. ✌️ From Australia.

[@RalfyCustoms]

Have a blast Nik, big love to you and yours buddy

[@messenger8279]

Thats the best solution Nik.

[@daveticehurst4191]

WHEEEEE, Eventually decided to weld it, should have done it two episodes back. Getting there now Nik.

[@hilltopmachineworks2131]

Glad Nik decided to weld it.

[@kentuckytrapper780]

Back at it early nik, great project...

[@RalfyCustoms]

Just a thought, if you drill a relief hole, at the end of the pinch slot, it will tighten up a whole lot easier Nik

[@silverbullet7434]

I too think a 3/8" drilled hole will help relieve the pressure needed to tighten the Arbor support. Id also drill an oil hole thru the support to lube the bearing . Id use an 1/8" drill and counter bore with 1/4" drill and add a wick to hold oil for the bearing.

[@kentuckytrapper780]

Good progress nik, until next week... Great video, keep'um coming..

[@lesbender236]

Since I may have missed it, did you indicate the right-angle head to be sure it was square? If not that may be why the mark wasn't in the center of the part

[@secretsix6]

try drilling a hole at the bottom of the saw cut

[@fredoropesa4939]

Why don’t you just weld it

[@jamiebuckley1769]

lazy machinist works twice as hard. and never gets it right.

[@NikColyerMachineWorks]

Ouch! Sure you want to be so negative.

[@jamiebuckley1769]

@@NikColyerMachineWorks nick im not trying to be negative im actualy trying to be a positive influence to you. i see you trying to do alot of scetchy things somtimes as one example when you dont take the proper time to clamp things in the mill and it moves and you ruin the part. as harold would say keep on keeping on nick. sorry if i sounded negative.

[@NikColyerMachineWorks]

@@jamiebuckley1769 Apology accepted.