Non-conformal mesh Thermal (battery) simulation | non share topology

[@mikeyuan6858]

Hello, if I think about the heat transfer contact points between batteries is it the original 28? Did you consider the heat transfer between batteries in your last video😄

[@WaqasLearnTech]

What do mean? I didn't understand your question. Can you please reformulate your question.

[@mikeyuan6858]

@@WaqasLearnTech Did you take into account heat transfer between cells in your simulation?

[@WaqasLearnTech]

@@mikeyuan6858 In this simulation, there is a gap between battery cells. Therefore, no heat transfer between the battery cells.

[@mikeyuan6858]

@@WaqasLearnTech Thank you for your reply. If I want to consider the heat transfer between batteries, where do I need to set it

[@WaqasLearnTech]

@@mikeyuan6858 For heat transfer between two bodies you just have to create contact (interface). You have to create contact between cells as I have created e.g between cell and bottom plate. Once you have contacte the heat transfer will take place automatically. To create/ handle contacts you can watch this video kzbin.info/www/bejne/eZLVioath995gJo Create contacts as discussed here and you are good to go.