Nozzle Drool & Nozzle Freeze Off

[@mattcox543211]

Quite literally at work right now trying to figure out how to stop the drool. Very helpful. Thank you very much

[@marcoemad3274]

Your videos are amazing and offer great assistance,thank you so much

[@injectionmoldingskillsmore1064]

Thanks so much for watching & the support. I try to give any knowledge that I can to others.

[@lucasflowers88]

I just found your channel, I've been working with injection molding for a few years now and I believe your videos will help me out, thank you

[@injectionmoldingskillsmore1064]

Thanks for watching & the support to the channel. Let me know if there is something you would like me to go over some day.

[@SekuImani]

Thanks man

[@injectionmoldingskillsmore1064]

Thanks for watching & the support to the channel I greatly appreciate it.

[@cubfendi8714]

Good video Dave. A couple videos back I think you asked about issues that people are having at their work. I finally thought of one and it's colour change from one to another. We already use Asaclean for cleaning, but any other info would be greatly appreciated.

[@injectionmoldingskillsmore1064]

I will do that for you in the next video bud. Thanks for watching.

[@jeremymcclanahan2389]

Thx for the info...I have a potential item for discussion. Thermolators - what about Reynolds number and how it can effect cooling efficiency with, both, too low of a Reynolds number or too high.

[@injectionmoldingskillsmore1064]

Yes I agree, Thanks for watching & the support to the channel.

[@hdvnma3519]

Now we are using vertical molding machine of JSW maker and have problem with open nozzle head drooling. How to confirm relating thinks. Thanks

[@injectionmoldingskillsmore1064]

What type of tip are you using? Are you using any decompression after screw recovery?

[@hdvnma3519]

@@injectionmoldingskillsmore1064 you mean about Open or shut-off nozzle? We're using open nozzle with PBT resin at 260 degree. That occur during recovery

[@injectionmoldingskillsmore1064]

@@hdvnma3519 Try to put a screw delay on it, so that the screw gets back right before mold opens. This will help a lot if you can do. Thanks

[@MrJzplastic]

You mentioned instead of cardboard “nozzle pieces you could buy” what are they called ? And do they work better than cardboard?

[@injectionmoldingskillsmore1064]

Husky & PPE on page 1244 has them. We don't use them here at our plant. E-Mail me & I will send you what they are & were to get them. [e-mail]

[@plasticworldindia]

Sir I am from India ,i beginner for injection molding process.can I asked a question sir?

[@injectionmoldingskillsmore1064]

Yes anything, Thanks for watching & the support.