Susan Thompson demos how to assemble an oil burner
Пікірлер: 16
@omarsharif24563 жыл бұрын
Ma'am u did a wonderful job I hope the audio can b better.But this vdo is very helpful for me bcoz I use the same beckett burner in my house. thnx a lot I hope in future u post more vdos
@Andrewatnanz3 жыл бұрын
Thats an F3 head. Its a beauty of a burner !
@bikernut19696 жыл бұрын
Great job... Very informative.
@johnsweda29994 жыл бұрын
What's the best material for a flange gasket I can't get one for my burner just used cardboard. No grommet for the wires a bit bad tons of vibration easily cut the insulation just make the cut-out a foldable piece in the Press over itself. Can't see where the air comes in
@dmcossy7 жыл бұрын
great video.
@stephenzies88678 жыл бұрын
Good Job !
@ronsbeerreviewstools43617 жыл бұрын
A very good video
@copkhan0074 жыл бұрын
It would be nice if you could rest the unit on something solid to keep it from falling forward. Plus you could use both hands instead of one. Good video👌
@szas67543 жыл бұрын
Exactly
@samanthadelfranco23777 ай бұрын
That’s why I have to tighten those she didn’t put enough elbow grease into the tube screws
@arefalizadeh59275 жыл бұрын
Thank you about this good vidio..plz provide a vidio for assembly a gas burner with 1500000 kql like rilo Rs180
@staym925 Жыл бұрын
They still make Beckett burners?
@acrservicesmathewr75657 ай бұрын
Yesss. The only burners that always have parts available
@Ratman_Bejo3 жыл бұрын
is thebest quality
@andydelle45093 жыл бұрын
I don't like the way the motor cord is just stuffed inside the junction box. It should have say a tyrap or something around the jacket to prevent the cord from being pulled out with the wires then exposed. Same goes for for the oil valve.