This video will cover how to setup the Okuma Crown for production #lathe #cnc #okuma
Пікірлер: 10
@ssleddens2 жыл бұрын
Nice
@aaronrunk4209 Жыл бұрын
Thanks
@user-zg5vd2gl6n9 ай бұрын
make a video on how to set up and bind instruments on Haas!!!!! Please .
@sachithpriyanandaАй бұрын
Hi, I am trying to get the load monitor work in OPS U100 L controllers , which is very similar to this as it looks, however i can not find where the load values installed after teaching mode, could you please help me with this
@aaronrunk4209Ай бұрын
I'll have to do some more looking on this however when it comes to the teaching mode it sounds more like a mazak but if you are wanting to make sure that your work offsets are in the right locations you could go into MDI and send it to a known location to see if it has been set correctly. I will say your values are on the screen somewhere it's just kind of hard to find them on these older machines
@jakub1518 ай бұрын
How would you load a program onto this machine using the RS-232 port?
@aaronrunk42098 ай бұрын
At minute 2:30 in this video. kzbin.info/www/bejne/p6SynKuvh7GUmKcsi=LR5tsmWtOEB7MYHq I'll go over how to load from an RS-232. I know it's not the same machine. However, it should be very close, just different buttons
@aaronrunk42098 ай бұрын
When I get back to the shop I'll look to see if I can figure out how to do it and if I can I'll record it and send it as well
@aaronrunk42098 ай бұрын
Thanks for watching
@jakub1518 ай бұрын
@@aaronrunk4209 No problem would be much appreciated! I have a Okuma Crown 762e OSP700L control fyi.