OMRON Timer H3CR-A (11 PIN) use on Motor control.

[@jesserhernandez4182]

Thank you Sir, I found you on your other channel (the crane circuit); no schematics. I'm glad KZbin's algo popped up this channel. GOOD STUFF!!!

[@tmelectricaltutorials2851]

thank you.. you will learn a lot to my channel just subscribe for update you can watch o lot of videos

[@garbo8962]

Almost positive this Omron very versatile timer is the same one that I connected to my homemade central vacuum system for my house over 35 years ago. Have it wired in as on off delay. When my kids were little they would plug in one of my central vacuum hoses clean up a little spill then leave the vacuum run. Have it set to turn off after 30 minutes. Rather then spend $250 or more for a central vacuum unit I used my 16 gallon shop vac. Installed a 120 to 24 volt transformer to power vac door switches . This timer can be used on several voltages & at least 5 functions like time delay on or off. Had another Omron timer on my old central air conditioning unit. Wife would move the old mercury thermostat to turn a on then change her mind turn if off then turn it back in causing the 30 amo circuit breaker to trip. Set up timer as a on delay timer set for 5 minutes .We had at least 30 of these Omron universal tickets at a company that I worked for and some were over ten years old and still working great.

[@JaykeSapalaran-iq3qs]

Great video tutorial Sir salamat sa PAG share Ng iyong kaalaman,mabuhay po kayo❤🇵🇭🫡

[@danielbartolome8807]

Thank you so much for this timer 11 pin, your video is very helpful i learn a lot to your channel master. God bless . 🙏

[@leondioquino4241]

Thank you sa effort nyo sir sa pag gawa ng video malakeng tulong ito for me ❤

[@WorkOrderMania]

Wipes for sure. It can appear as string or rope. Wipes do a great job causing pump failures in sewer lift stations and water treatment plants. I never used the plumbing stack to clean out the drain pipes but it is effective. I would rather pull a toilet and reset it when I am done.

[@tmelectricaltutorials2851]

hello bro. i work before on power generation plant at water treatment and i dixed many sewage pump . two pumps submersible and using 4 float switch with higher level alarm.

[@popaulmiyanom.8924]

This channel is so amazing. Thanks Prof for sharing with us.

[@ozparky]

good job Teacher!!!!

[@tmelectricaltutorials2851]

Thank you! 😃

[@leanierejuso5401]

Thank you Sir, but for safety turn off main supply before pulling out the timer or any components...that will extend their life and ours too :)

[@tmelectricaltutorials2851]

yes ofcourse must turn off main power before doing anything.

[@chunnuvaiyt7675]

👌👍❤️

[@setarekiwakanivuga6589]

Can this timer H3CR-A used for star delta starter

[@tmelectricaltutorials2851]

yes

[@sidharthk6335]

Hai sir... Can you please do wireing for service lift ground + 4 floor with Contactor, limit switch, and relay only

[@max5gb]

No veo SD 360p mal. Mojer HD y FULL HD

[@sharifelectronicdevices6771]

❤

[@ron514ron]

tanong lang bossing sa neutral mo or even sa live wire pwede kaba mag lagay ng series of jumper tapos dun mo lagay L1 or L2 mo then doon mona ilagay lahat live or neutral wire mo? thank you 👊🏻 watching from montreal pala.

[@tmelectricaltutorials2851]

Pweding mglagay ng jumper sa line one or line 2 pero hindi pwdeng magsalubong kelangan daan sa coil or ilaw pra hindi mg short circuit. Hindi pumotok.