ONE PIECE Character - Killer- Cosplay making

Killer helmet/mask & gauntlet props making video.
I used a downloaded patterns and followed instructions of Base Mask tutorial created by Pigtail Channel. His video is very detailed and easy to understand. All of his masks look fantastic!
• 【簡単】 ベースマスクテンプレートの作り方 ...

[@ada_adaa]

SO GOOD😮😮😮😮😮

[@sewcraftymum877]

Thank you so much!!💖💖💖

[@samivancic5186]

How did you cut the holes? ^^ With just carpet knife or something else? Did you also add zipper to this head peace to make it easier to put on and take off?

[@sewcraftymum877]

I used the precision knife (triangular type) to cut the holes because it was easier to work with than the utility knife. And yes, I attached the zipper at the back side using Barge rubber cement. Barge brand is a little more expensive than the other brand, but it works so much better! The zipper stays on foam without peeling off even though I put on my helmet on and took off several times during the convention. 😃

[@coolkcroyale]

Thanks this is awesome!

[@sewcraftymum877]

Thank you💗

[@reidlachapelle2979]

How big are the holes? And how much spacing between stripes?

[@sewcraftymum877]

Sorry for the late response. Hole diameter=1" and Stripe width=1.5" Thanks for watching and hope your helmet turns out well.🙂

[@ruanoloveira6555]

Legal

[@sewcraftymum877]

Thanks!

[@gob9318]

What sized foam did you use?

[@sewcraftymum877]

Hi! I used the fitness board (3/8" thickness) for the base helmet and the foam sheet (2mm thickness) for the stripes. The round pieces on each side of helmet: large white circle piece=2mm, and small blue circle piece=3/8". For the weapon prop, I used 3/8" foam board mainly with 2mm foam sheet for outer layer decoration. I hope this helps! Thanks for watching my video :)