One Way Bearing Installation & Inspection

[@Brutus1819]

Great video watch so many to find out what you put in a great video

[@LelandsFarm]

Thank you for this video, saved me big time!

[@jasondudar9699]

Great video. The manual is a little convoluted in its description, this helped me to ensure I was doing it right.

[@slapnutzracing2152]

I have a 2000 suzuki king quad 300 4x4 and I didn't take note of witch direction when I pulled it apart. What direction should it go any info would be greatly appreciated because I don't have a manual and can't find anything on the internet.

[@mikehudson7245]

Im changing a one way bearing on my 2011 Polaris ranger ranger 900 xp it's the one that's for starting the motter?

[@timbonnis1146]

hello ! does the wet clutch make a noise when it is starting to go

[@justinkroeker1464]

What happens if the bearing is bad or you take it out?

[@codyallen6547]

How do you take off the wet clutch I can’t find any info anywhere

[@dosstheboss100]

What if there are chatter marks on the wet clutch shaft

[@SGTDuckButter]

I only wish I had watched this video the first time I put it all back together.

[@johnnylightning5242]

I have CForce 500HO. Tried to crank in cold weather (single digits)After 3 quick cranks with no startup the starter stopped cranking the engine. The starter turns fine.. Solenoid and battery good. I hear and feel starter is turning some engine components but again is not cranking engine. Do you suspect one way bearing? If I remove housing and just try to turn clutch assembly and if it spins in both directions then am I safe to say bearing took a crap? It only has 250 miles and is 1.5 years old? Do you know of any other issue or component that may have been affected ? Thank you

[@theamishhitman71]

did u fix this issue?

[@elliottlong291]

Great video

[@markynzon]

If the kickstart is loose, is it possible that the one way bearing is not functioning? Or they are both connected in kickstaring?

[@plainandsimple1]

If the one way bearing is bad itll kick but not actually turn over the motor.

[@michaelhorsford403]

I dropped my one way bearing it exploded i got ot back together even replaced the spring cause it was in terrible shape .... Anyway after my new clutch install ... The mistake of dropping that 1 part is preventing my atv from moving lol

[@exupakias]

Super

[@Gokywildcats11]

Is this a known problem on the massimo

[@jsimm4587]

What happens if it’s in backwards?

[@JC-ms9tg]

It slams into gear -

[@justinsparks631]

What does it do if u have it on wrong

[@JC-ms9tg]

It slams into gear.

[@sunnyray7819]

Looks like the same as the Eiger aswell...

[@blixtkrig]

Why is it a need for a one way bearing

[@dougcoleburn1579]

engine braking when you let off the gas

[@ПавелКостерин-к6т]

Вот наверное на котах сцепление и брякает...оно в руках издает такой же звук